Skip to content

Tips: Ribber Cast on Combs

The prevailing opinion is that you must never pull the ribber COC wire all the way out when hanging it between beds. I have always followed that advice … until now. I’ve been struggling to suspend a full-length COC on a mid gauge SK860 and SR860 when I have 120 sts in place. I freely admit that I begin my hat projects a little different than a lot of machine knitters. I like to crochet cast on on the main bed, knit a row, move stitches into a 2×2 rib configuration, then suspend the COC and large ribber weights. That method gives me the edge I prefer on hats. It also presents its own problems on hanging a COC. Finally, after several frustrating attempts recently, I pulled the wire all the way out and pushed the COC into place where it belonged. It was so much easier! The wire slipped into the holes without any difficulty and all the way through. I have a pretty heavy wire on my COC; it’s not a flimsy little wire. That could be part of the recipe for success also. So my advice to you today is to research a technique, but don’t be afraid to reach out for a new resolution.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: